Blog

The E-code only shows up if you get  1 red light, otherwise there is no video output and you cant see it(for 2, 3 and 4 red lights)...(in rare cases it doesnt even show up if you get 1 red light, proceed with the secondary error code then)

An E-code consist out of 3 letters, it always starts with an E that is followed by two numbers, for example your error code would be E74 in the picture below!

The specific type of hardware failure can be determined by a \"hidden\" error code

* Turn the xbox 360 on, and wait till the 3 red lights are flashing.
* Press and hold the sync up button (the small white one), while holding that button press the eject button.
* The LEDs will now blink the first number in the code (as described below).
* Release the eject button and press it again.
* The LEDs will now blink the second number of the code.
* Release the eject button and press it again.
* The LEDs will now blink the third number of the code.
* Release the eject button and press it again.
* The LEDs will now blink the forth number of the code.
* Release the eject button and press it again.
* The LEDs will go back to the 3 red flashing lights.
You should be able to determine the difference between the 3 flashing lights and the error code lights by the rate in which they flash.

Here is how you interpret the LEDs to get the code number:

* All four lights flashing - 0
* One light flashing - 1
* Two Lights flashing - 2
* Three lights flashing - 3

You will for example get an error code like 0102 if you get 4 lights after the first click, 1 after the second, 4 after the third and 2 after the fourth click of the eject button...

Comments (0)

Subscribe to this comment's feed

Name

Email

Website

Title

Comment

smaller | bigger

Subscribe via email (Registered users only)

I have read and agree to the Terms of Usage.

Write the displayed characters

Add Comment